Handmade Silver Wedding Ring With Hammered Finish - All Birthstone™

Handmade Silver Wedding Ring With Hammered Finish - All Birthstone™

 

birthstone rings

 

The UK ring size and band width, from 3mm to 8mm should be chosen when you place your order.

 

1. Ring size comparison in different countries (Conversion Table)

2. How to measure your finger size and how to find the right ring size?

Please print this Sizing Tool (click).  You have two choices with this tool. The first, please put your existing ring onto the circles and find your size. Alternatively, scissor out the measuring bar on the right of the paper and use it to measure your finger size. Please follow the instructions in the above PDF document. We recommend that you can use both two methods to make the result more accurate.

Let the bead slide to the bottom of the eye pin. Directly above the bead, use your pliers to bend the eye pin approximately 45 degrees. Using wire cutters, trim this to about half an inch in length. Using small round pliers, grasp the tip of the wire and start looping it around the pliers tip. Don't give up if your eye pin loop is not directly round - practice makes perfect!

Write a review

Note: HTML is not translated!
    Bad           Good

Captcha
  • £68.00
  • Ex Tax: £68.00

Available Options

 (+£5.00)
 (+£5.00)
 (+£5.00)
 (+£5.00)
 (+£5.00)
 (+£5.00)
 (+£5.00)
 (+£5.00)
 (+£5.00)
 (+£5.00)
 (+£5.00)
 (+£5.00)